Garmin STRIKER PLUS 9 Quick Start Manual - Page 5
Browse online or download pdf Quick Start Manual for Marine Equipment Garmin STRIKER PLUS 9. Garmin STRIKER PLUS 9 8 pages. Compass safe distance
Also for Garmin STRIKER PLUS 9: Owner's Manual (16 pages), Quick Start Manual (2 pages)
Print Page
3
Select
to add a turn to the route.
4
Repeat to add all of the turns in the route.
5
> Navigate To.
Select
6
Select an option.
Marking and Navigating to a Man Overboard Location
From any screen, select
> Man Overboard > Yes.
The fishfinder sets a direct course back to the location.
Mapping a Body of Water Using the Garmin Quickdraw
Contours Feature
Before you can use the Garmin Quickdraw Contours feature, you must have
sonar depth and your GPS position.
1
Select Quickdraw Map >
> Quickdraw Contours > Start Recording.
2
When recording is complete, select
Recording.
Troubleshooting
My device does not turn on
• Push the power cable all the way into the back of the device.
Even if the cable seems to be connected, you should push firmly so that it is
fully seated.
• Make sure the power source is generating power.
You can check this several ways. For example, you can check whether other
devices powered by the source are functioning.
• Check the fuse in the power cable.
The fuse should be located in a holder that is part of the red wire of the power
cable. Check that the proper size fuse is installed. Refer to the label on the
cable or the installation instructions for the exact fuse size needed. Check the
Quick Start Manual
™
> Quickdraw Contours > Stop
fuse to make sure there is still a connection inside of the fuse. You can test
the fuse using a multimeter. If the fuse is good, the multimeter reads 0 ohm.
• Check to make sure the device is receiving at least 10 Vdc, but 12 Vdc is
recommended.
To check the voltage, measure the female power and ground sockets of the
power cable for DC voltage. If the voltage is less than 10 Vdc, the device will
not turn on.
My sonar does not work
• Push the transducer cable all the way into the back of the device.
Even if the cable seems to be connected, you should push firmly so that it is
fully seated.
• Press , and ensure sonar is enabled.
• Select the correct transducer type (page 4).
Garmin Support Center
Go to support.garmin.com for help and information, such as product manuals,
frequently asked questions, videos, software updates, and customer support.
5