AEG FAVORIT 44080 I User Manual - Page 12

Browse online or download pdf User Manual for Dishwasher AEG FAVORIT 44080 I. AEG FAVORIT 44080 I 40 pages. Electrolux user instructions dishwasher favorit 44080 i
Also for AEG FAVORIT 44080 I: User Information (48 pages), User Information (40 pages)

Print Page

Prior to using for the first time

Setting the amount of rinse aid required

Only change the amount dispensed, if smears, milky spots (reduce the amount)

or dried on water spots (increase the amount) can be seen on glasses and dishes.

(See section "If dishwashing results are not satisfactory".) The dosage can be set

from 1 6. The dosage is pre set to "4" in the factory.

1. Open the dishwasher door.

2. Press the release button on the rinse aid

compartment.

3. Open the cover.

4. Set the dosage level.

5. Press the lid shut until it clicks into place.

6. If rinse aid has leaked out, wipe it away

with a cloth.

Activating rinse aid inflow when 3in1 function is selected

If the 3in1 function is not selected, the rinse aid inflow is always activated.

If the 3in1 function is selected due to the use of 3in1 detergent, the rinse aid in

flow is deactivated. If the dishes then do not dry sufficiently, you should re acti

vate the rinse aid inflow (see also section "Using 3in1 detergents").

1. Press the ON/OFF button.

If the only LED indicator illuminated is one that belongs to a programme button,

this means that this dishwashing cycle has been activated. The dishwashing cy

cle must be deselected:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds.

The LED indicators of all the programme buttons that can be selected light up.

2. Press function buttons 2 and 3 simultaneously and keep them pressed.

The LED indicators for function buttons 1 to 3 will flash.

3. Press function button 2.

The LED indicator for function button 2 will flash.

The indicator for the end of the dishwashing cycle will display the current setting:

Indicator for the end of the cycle is lit:

Indicator for the end of the cycle is not lit:

4. Pressing function button 2 activates and deactivates the rinse aid dispensing function.

5. When the rinse aid inflow setting is correct, press the ON/OFF button.

The setting for the rinse aid inflow is now saved.

Rinse aid inflow activated when 3in1 on

Rinse aid inflow deactivated when 3in1 on

(factory setting)