Brother DCP-150C Quick Setup Manual - Page 20

Browse online or download pdf Quick Setup Manual for All in One Printer Brother DCP-150C. Brother DCP-150C 26 pages.
Also for Brother DCP-150C: Quick Setup Manual (2 pages)

Print Page

STEP 2

Installing the Driver & Software

For USB Interface Users

(For Mac OS

Important

Make sure that you have finished the

instructions from STEP 1 Setting Up the

Machine on pages 4 through 11.

Note

• For Mac OS

Mac OS

X 10.2.4 or greater. (For the latest

information for Mac OS

http://solutions.brother.com)

• Make sure there are no memory cards or a USB

Flash memory drive inserted into the media drives

or USB direct interface at the front of the machine.

Using both hands, use the plastic tabs on both

sides of the machine to lift the scanner cover

until it locks securely into the open position.

Connect the USB cable to the USB socket

marked with a

USB socket inside the machine as shown

below.

X 10.2.4 or greater)

X 10.2.0 to 10.2.3 users, upgrade to

X, visit

symbol. You will find the

Carefully guide the USB cable into the trench

as shown below, following the trench around

and toward the back of the machine.

Then, connect the cable to your Macintosh

Improper Setup

• DO NOT connect the machine to a USB port on

a keyboard or a non-powered USB hub.

Brother recommends that you connect the

machine directly to your Macintosh

• Make sure that the cable does not restrict the

cover from closing, or an error may occur.

• Make sure you use a USB 2.0 cable that is no

longer than 2 metres.

Lift the scanner cover to release the lock

Gently push the scanner cover support down

and close the scanner cover

Note

Make sure that the machine is turned on by

connecting the power cord.

Turn on your Macintosh