Fujitsu ABT series Operating Manual - Page 14

Browse online or download pdf Operating Manual for Air Conditioner Fujitsu ABT series. Fujitsu ABT series 18 pages. Floor console/under ceiling dual type
Also for Fujitsu ABT series: Operating Manual (20 pages), Operating Manual (20 pages), Operating Manual (20 pages)

Print Page

SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE

When two or more air conditioners are installed in a room and the remote control

unit is operating an air conditioner other than the one you wish to set, change the

signal code of the remote control unit to operate only the air conditioner you wish

to set (four selections possible).

When two or more air conditioners are installed in a room, please contact your

retailer to set the individual air conditioner signal codes.

Selecting the Remote Control Unit Signal Code

Use the following steps to select the signal code of the remote control unit. (Note

that the air conditioner cannot receive a signal code if the air conditioner has not

been set for the signal code.)

Press the START/STOP button (Fig. 5 I) until only the

clock is displayed on the remote control unit display.

Press the MASTER CONTROL button (Fig. 5 D) for at

least five seconds to display the current signal code

(initially set to ).

Press the

code between

play to the air conditioner signal code.

Press the MASTER CONTROL button again to return

to the clock display. The signal code will be changed.

If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock

display. In this case, start again from step 1.

The air conditioner signal code is set to A prior to shipment. Contact your retailer to change the signal code.

The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a

signal code other than signal code A, reset the signal code after replacing the batteries.

If you do not know the air conditioner signal code setting, try each of the signal codes (

code which operates the air conditioner.

buttons (Fig. 5 E) to change the signal

. Match the code on the dis-

To operate only

one of multiple

air conditioners

) until you find the