AEG OKO FAVORIT 40660 i User Instructions - Page 31
Browse online or download pdf User Instructions for Dishwasher AEG OKO FAVORIT 40660 i. AEG OKO FAVORIT 40660 i 44 pages. Aeg dishwasher
Also for AEG OKO FAVORIT 40660 i: User Information (44 pages), User Instructions (40 pages), User Instructions (44 pages), User Instructions (48 pages)
Print Page
...Error messages are displayed.
If any of the indicators in the control panel, as listed in the table below,
are flashing or are illuminated, you can probably rectify the fault your-
self.
Malfunction
The programme indicator
for the selected programme
is flashing: error code
is displayed in the multi-dis-
play: there is no water run-
ning into the dishwasher.
The programme indicator
for the selected programme
is flashing, error code
is displayed in the multi-dis-
play.
Å 30
Error code
in the multi-display.
After rectifying an Å 10 or Å 20 error, press the button for the pro-
gramme that has been started. The programme will continue.
If the fault is displayed again, please contact customer service.
For all other errors displayed, please contact customer service, stating
3
the error code. (See chapter "Customer Service").
Possible cause
The tap is blocked or furred
with lime-scale
The tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Å 10
Filters in the base of the
washing compartment are
blocked.
The water inlet hose has not
been correctly laid.
The siphon is blocked.
Å 20
The water drain hose has
not been correctly laid.
The leak prevention system
is displayed
has been triggered.
Operating Instructions
Remedy
Clean the tap
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
selected programme,
then cancel the pro-
gramme by pressing
RESET (see chapter:
"Starting a programme");
clean out the filters (see
chapter: "Cleaning the
filters").
Check hose installation.
Clean out siphon.
Check hose installation.
Turn off the tap and
contact customer serv-
ice.
31