AEG 111 K Operating Instructions Manual - Page 18

Browse online or download pdf Operating Instructions Manual for Hob AEG 111 K. AEG 111 K 20 pages. Electric hob
Also for AEG 111 K: Operating Instructions Manual (16 pages), Operating Instructions Manual (18 pages), Operating Instructions Manual (16 pages)

Print Page

Electrical connections

Any electrical work required to install this hob should be carried out

by a qualified electrician or competent person, in accordance with the

current regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability should these safety measures not be

observed.

This hob is designed to be connected to a 230-240V 50Hz AC electrical

supply.

Before switching on, make sure the electricity supply voltage is the same as

that indicated on the hob rating plate. The rating plate is located on the

bottom of the hob. A copy is attached on the back cover of this book.

The hob is supplied without supply cord. A 3 core flexible supply cord must

be fitted, in accordance with the specification given in the relevant tables.

1) Remove the mains terminal cover

plate from the underside of the

hob, to expose the mains terminal

block.

2) Loosen the two cable clamp screws

and lift the top section of the

clamp enough to allow the cable

to be passed through.

3) Connect the red (live) wire to the

terminal which is marked with the

number 1.

4) Connect the black (neutral) wire to

the terminal which is marked with the number 4.

5) After fitting a green or yellow/green sleeve over the bare copper

wire (earth wire), connect the exposed end to the terminal which is

marked with the earth symbol

NOTE: The earth wire should be about 2 cm. longer than the live

and neutral wires.

6) Secure the cable by means of the clamp screws and refit the

terminal block cover.

FO 0488

or with the number 5.