Mounting on a wall
For proper ventilation, allow a clearance of 100 mm
(3.94 inches) on each side and from the wall. Detailed
instructions are available from your dealer, see the
optional Tilt Wall Mounting Bracket Installation and
Setup Guide.
100 mm
(3.94 inches)
If you intend to mount the Monitor set to a wall, attach
Wall mounting interface (optional parts) to the back of
the set.
When you install the Monitor set using a wall mounting
interface (optional parts), attach it carefully so it will not
drop.
1
If you use screw longer than standard, the monitor
might be damaged internally.
2
If you use improper screw, the product might be dam-
aged and drop from mounted position.
In this case, LG Electronics is not responsible for it.
Model
20MK4 series 22MK4 series
24MK4 series 22MN430H
24MN430H
Wall Mount (A x B)
75 x 75
Standard screw
M4
Number of screws
4
Model
27MK4 series
Wall Mount (A x B)
100 x 100
Standard screw
M4
Number of screws
4
100 mm
(3.94 inches)
100 mm
(3.94 inches)
100 mm
(3.94 inches)
Wall Mount (A x B)
y
CAUTION
Disconnect the power cord first, and then move
y
or install the Monitor set. Otherwise electric
shock may occur.
If you install the Monitor set on a ceiling or
y
slanted wall, it may fall and result in severe
injury.
Use only an authorized LG wall mount and
y
contact the local dealer or qualified personnel.
Do not over tighten the screws as this may
y
cause damage to the Monitor set and void your
warranty.
Use only screws and wall mounts that meet
y
the VESA standard. Any damages or injuries by
misuse or using an improper accessory are not
covered by the warranty.
Screw length from outer surface of back cover
y
should be under 8mm.
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
NOTE
Use the screws that are listed on the VESA
y
standard screw specifications.
The wall mount kit will include an installation
y
manual and necessary parts.
The wall mount bracket is optional. You can
y
obtain additional accessories from your local
dealer.
The length of screws may differ depending on
y
the wall mount. Be sure to use the proper length.
For more information, refer to the instructions
y
supplied with the wall mount.
13
Back Cover
Max.8mm