AEG 72950M User Manual - Page 34

Browse online or download pdf User Manual for Washer AEG 72950M. AEG 72950M 40 pages.

Print Page

Installation

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet hose,

be sure to tighten the ring nut again to

prevent leaks.

4. Connect the hose to a tap with a 3/4"

thread. Always use the hose supplied with

the appliance.

The inlet hose must not be lengthened. If it is

too short and you do not wish to move the

tap, you will have to purchase a new, longer

hose specially designed for this type of use.

Installation should comply with local water

authority and building regulations require-

ments. Check the minimum water pressure

required for safe operation of the appliance in

the chapter "Technical Data".

Water-stop device

The inlet hose is provided with a water stop device,

which protects against damage caused by water

leaks in the hose which could develop due to nat-

ural ageing of the hose. This fault is shown by a

red sector in the window «A» . Should this occur,

turn the water tap off and refer to your Service

Centre to replace the hose.

The end of the drain hose can be positioned in three ways:

1. Hooked over the edge of a sink using the plastic hose guide supplied with the

machine.

In this case, make sure the end cannot come unhooked when the machine is emptying.