AEG 9000 Series User Manual - Page 19

Browse online or download pdf User Manual for Washer AEG 9000 Series. AEG 9000 Series 32 pages.
Also for AEG 9000 Series: User Manual (48 pages), User Manual (8 pages)

Print Page

9.11 Programme end

Clean the filter and drain the

water container after each

drying cycle. (See chapter

CARE AND CLEANING.)

If the drying cycle is finished, the symbol

appears on the display. If the Buzzer

option is activated, the acoustic signal

sounds intermittently for 1 minute.

If you do not turn off the

appliance, the anti-crease

phase starts (not active with

all programmes). Flashing

execution of the anti-crease

phase. Laundry can be

removed during this phase.

10. HINTS AND TIPS

10.1 Ecological hints

• Spin the laundry well before drying.

• Do not exceed the load sizes which

are specified in the programmes

chapter.

• Clean the filter after each drying

cycle.

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• The water from the water container

can be used to iron the clothes. You

must first filter the water to eliminate

remaining textile fibres (simple coffee

filter is suitable).

• Always keep the airflow slots at the

bottom of the appliance clear.

• Make sure there is good airflow where

the appliance is to be installed.

10.2 Adjustment of default

dryness level

To change the default dryness level:

1. Turn the appliance on.

2. Wait approximately 8 seconds.

3. Select 1 of the available

programmes.

4. Touch and hold down the Quiet and

Time Dry buttons at the same time.

symbol signals the

To remove the laundry:

1. Push the On/Off button for 2 seconds

to turn the appliance off.

2. Open the appliance door.

3. Remove the laundry.

4. Close the appliance door.

Possible causes of unsatisfactory drying

results:

• Inadequate default dryness level

settings. See chapter

default dryness level

• Room temperature is too low or too

high. Optimal room temperature is

between 18°-25°C.

One of the symbols appears on the

display:

- Maximum dryness

- Extra dryness

- Standard dryness

5. Touch the Start/Pause button

repeatedly until you reach the

desired dryness level.

Dryness

level

Maximum

dryness

Extra dry‐

ness

Standard

dryness

6. To memorise the setting touch and

hold down the Quiet and Time Dry

buttons at the same time for

approximately 2 seconds.

ENGLISH

Adjustment of

Display symbol