Fujitsu Lifebook A3040 Software Manual - Page 9

Browse online or download pdf Software Manual for Laptop Fujitsu Lifebook A3040. Fujitsu Lifebook A3040 29 pages. Bios setup utility
Also for Fujitsu Lifebook A3040: Bios Manual (24 pages)

Print Page

I/O Device Configuration Submenu of the Advanced Menu

The I/O Device Configuration submenu provides the

ability to set the I/O addresses and interrupt levels for

the serial, infrared, and parallel ports of your notebook.

C A U T I O N

I/O addresses, DMA channels, and Interrupt levels can

be entered in various ways, including via the BIOS setup

utility, the control software for the I/O device, or the

hardware. If any two ports or devices, serial or parallel,

have the same I/O address assigned, your notebook will

not function normally. Please keep a record of original

settings before making any changes in the event that a

restoration is required. See your hardware and software

documentation as well as the setup utility to determine

settings, limitations, etc.

Serial port A:

Base I/O address:

Interrupt:

Serial port B:

Mode:

Base I/O address:

Interrupt:

DMA Channel:

Parallel Port:

Mode:

Base I/O address:

Interrupt:

Floppy disk controller:

IDE controller:

Help

ESC

Exit

PhoenixBIOS Setup Utility

Advanced

I/O Device Configuration

Select Item

-/Space

Select Menu

Figure 4 I/O Device Configuration Submenu

P O I N T

To prevent IRQ and address conflicts, avoid changing

the default settings. If you must change the settings,

you can call 1-800-8FUJITSU for technical assistance.

C A U T I O N

The BIOS will warn you of a resource conflict by placing

a yellow asterisk next to each device that is in conflict.

P O I N T

All I/O addresses in Table 4 are in hexadecimal.

[Enabled]

[3F8]

[IRQ 4]

[Enabled]

[FIR]

[2E8]

[IRQ 3]

[DMA 3]

[Enabled]

[Bi-directional]

[378]

[IRQ 7]

[Enabled]

[Both]

Change Values

Enter

Select

Sub-Menu

A d v a n c e d M e n u

Item Specific Help

Configure serial port A

using options:

[Disabled]

No configuration

[Enabled]

User configuration

[Auto]

BIOS or OS chooses

configuration

Setup Defaults

F10

Save and Exit