Brother P-touch E550WVP Quick Setup Manual - Page 26

Browse online or download pdf Quick Setup Manual for Label Maker Brother P-touch E550WVP. Brother P-touch E550WVP 47 pages.

Print Page
GETTING STARTED
2
Insert the rechargeable Li-ion battery into the battery
compartment.
3
Confirm that the hooks on the edge of the rear cover are inserted correctly, and then
reattach the cover.
If you cannot attach the rear cover, check to ensure the white lever is in the up position. If not, lift
the lever, and then attach the cover.
 Removing the Rechargeable Li-ion Battery
Remove the battery cover and the rechargeable Li-ion battery, and then reattach the battery
cover.
 Charging the Rechargeable Li-ion Battery
The rechargeable Li-ion battery can be charged while it is inserted in the P-touch labeling
system. Perform the following procedure to charge the rechargeable Li-ion battery.
• Before using the rechargeable Li-ion battery, use the following procedure to charge it.
• Up to 6 hours may be needed to fully charge the rechargeable Li-ion battery.
1
Make sure that the P-touch labeling system is turned off. If the P-touch labeling system
is turned on, press and hold the
2
Make sure that the rechargeable Li-ion battery is installed in the P-touch labeling
system.
3
Use the AC adapter to connect the P-touch labeling system to
an AC power outlet.
The LED next to the adapter connector turns on during
charging, it goes off when the rechargeable Li-ion battery is
fully charged. The battery level indicator on the display will fill
three bars
 Stopping Rechargeable Li-ion Battery Charging
To stop the rechargeable Li-ion battery from charging, disconnect the AC adapter.
26
Power Supply
(Power) button to turn it off.
.