AEG L 71260 SL User Manual - Page 10
Browse online or download pdf User Manual for Washer AEG L 71260 SL. AEG L 71260 SL 36 pages.
Also for AEG L 71260 SL: User Manual (36 pages)
10
D
1) Only available for Spin/Drain programme.
2) The symbols appear on the display when the related phase or function is set.
START/PAUSE BUTTON
Press button
programme.
DELAY START BUTTON
Press button
programme from 30 minutes to 20
hours.
TIME SAVE BUTTON
Press the button
programme duration.
• Press one time to set 'Shortened du-
ration' for items with daily soil.
• Press two times to set 'Extra Quick'
for items with almost no soil.
EXTRA RINSE BUTTON
Press button
to a programme.
Use this function for persons allergic to
detergents and in areas where the wa-
ter is soft.
Downloaded From WashingMachine-Manual.com Manuals
• The programme time
When the programme starts, the time decreases with steps of 1 minute.
• The delay start
When you press the delay start button, the display shows the delay start
time.
• Alarm codes
If the appliance has a malfunction, the display shows alarm codes. Refer
to 'Troubleshooting' chapter.
• Err
The display shows this message for some seconds if:
– You set a function that is not applicable for the programme.
– You change the programme while it operates.
The indicator of the Start/Pause button
•
When the programme is completed.
to start or interrupt a
4
to delay the start of a
5
6
to decrease the
Some programmes accept only
one of the two functions.
7
to add rinsing phases
4
STAIN BUTTON
Press button
to a programme.
Use this function for laundry with hard
stains to remove.
5
When you set this function, put the
stain remover into compartment
6
SPIN BUTTON
Press this button to:
• Decrease the maximum speed of the
spin phase when you set a pro-
gramme.
7
• Deactivate the spin phase.
• Activate the 'Rinse Hold' function.
Set this function to prevent fabric
creases. The appliance does not
drain the water when the programme
is completed.
4
flashes.
8
to add the stain phase
8
This function increases the pro-
gramme duration.
This function is not available
with a temperature lower than
40° C.
9
The display shows only the spin
speeds available with the set
programme.
.