AEG L61470WDBI User Manual - Page 17
Browse online or download pdf User Manual for Washer AEG L61470WDBI. AEG L61470WDBI 36 pages.
Also for AEG L61470WDBI: User Manual (40 pages)
Print Page
If, for any reason, it is necessary to open
it, firstly press button Start/Pause to set
the machine to pause.
If the indicator Door after a few minutes
goes off, the door can be opened.
If the indicator Door stays on and the
door remains locked, this means that the
appliance is already heating or that the
water level is too high. In this case the
door cannot be opened.
If you cannot open the door but you
need to open it, turn the programme dial
to Off to switch the appliance off. After a
few minutes the door can be opened
(pay attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options
again. Press button Start/Pause to start
the programme again.
10.10 At the end of the
programme
The appliance stops automatically. The
indicator of button Start/Pause, the
indicators Washing and Door go off. A
blinking
If you have set a programme or an
option that ends with water in the tub,
the indicator Door remains on. The door
11. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
11.1 Drying setting
The recommended load size
is 4 kg for cottons and linen,
and 2 kg for synthetic items.
1. Load the laundry one item at a time.
2. Turn the programme dial to the
programme applicable for the items
to dry (cottons or synthetics).
will appear on the display.
is locked. The water must be emptied
out before opening the door. During this
time the drum continues to turn at
regular intervals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
Off.
• Set the DRAIN or SPIN programme.
• Reduce the spin speed, if needed.
• Press button Start/Pause.
• When the programme has finished
the display shows a blinking
indicator Door goes off. The door can
be opened.
Turn the programme selector dial to Off
to switch the appliance off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
10.11 Stand by
Once the programme has finished, after
a few minutes the energy saving system
will activate. The display will dim. Press
any button to deactivate the Stand By
function.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
11.2 Timed drying
1. Press the button Drying Time again
and again to set the time value (see
the «Programmes for timed drying»
table).
• Each time you press this button
the time value increases by 5
minutes.
ENGLISH
17
. The