Fujitsu BS2000 SE300 Operating Manual - Page 11

Browse online or download pdf Operating Manual for Server Fujitsu BS2000 SE300. Fujitsu BS2000 SE300 22 pages. Server unit x86
Also for Fujitsu BS2000 SE300: Manual (42 pages)

Print Page

2.2.1 Controls

Control

Meaning

Identification (ID) button

The ID indicators light up (blue) on the front and on the rear of the Server Unit when the ID button is

pressed. The two ID indicators are synchronized.

On/Off switch

When the Server Unit is switched off, it is switched on again by pressing the On/Off switch once.

When the Server Unit is in operation, it is switched off by pressing the On/Off switch once (this takes a

little time).

Normally the system may only be switched on or off by Customer Support. The customer should only

perform an "emergency power off", see SE x86 "Switching off in an emergency" in the Basic Operating

Manual [ ].

For information on switching on and starting the SE300 and on switching it off and shutting it down,

see "Switching the SE x86 on and off" in the Basic Operating Manual [ ].

CAUTION!

Loss of data

When the On/Off switch is pressed and held down for several seconds, Server Unit

operation is terminated ungracefully and abruptly. Notify Customer Support.

The On/Off switch does not disconnect the server from the voltage grid. To disconnect from

the voltage grid completely, remove the power plug(s).

RST or

Reset button

RESET

Pressing the Reset button reboots the Server Unit.

CAUTION!

Possible loss of data!

NMI button

NMI

CAUTION!

Do not press! Possible loss of data! The NMI button may only be used by Customer Support.