Fujitsu ETERNUS DX Disk Configuration Manual - Page 9

Browse online or download pdf Configuration Manual for Server Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 35 pages. Server connection, fcoe for linux driver settings for converged network adapter cards
Also for Fujitsu ETERNUS DX Disk: User Manual (35 pages), User Manual (42 pages), Configuration Manual (28 pages), Configuration Manual (44 pages), Configuration Manual (28 pages), Configuration Manual (29 pages), Configuration Manual (25 pages), Configuration Manual (32 pages), Configuration Manual (31 pages), Configuration Manual (43 pages), Configuration Manual (21 pages), Configuration Manual (24 pages)

Print Page

Fujitsu ETERNUS DX Disk Configuration Manual

Chapter 1

Setup Procedure for Emulex Converged Network Adapter Cards

1.2

Setting Up the Converged Network Adapter Cards

The following shows an example of this.

Host name

IP Address

Physical slot

name

slot0

Details of contents

The details of contents for the WWN instance management table for the server are as follows:

Host name:

Record the host name.

IP Address:

Record the IP address of the server.

Physical slot name:

Record the slot position of installed Converged Network Adapter card.

Converged Network Adapter card WWN:

Record the value of [Port Name].

Instance name:

Not necessary to record.

Physical address:

Record the value of [Mem Base].

Cable tag:

Record a tag name which indicates the connection path (relationship between the connected device

and the port).

Press the [Esc] key to quit the Emulex OneConnect FCoE BIOS Utility.

When installing two or more Converged Network Adapter cards to the server, first turn off the server,

then repeat

If multiple Converged Network Adapter cards are already installed in the server at the time of pur-

chase, the one-to-one relationship between the WWNs and the Converged Network Adapter cards

cannot be recognized. The WWNs that are obtained in this section may need to be repeatedly regis-

tered and set up on the ETERNUS DX until a server recognizes the ETERNUS DX logical disks.

For details about ETERNUS DX settings, refer to "FUJITSU Storage ETERNUS DX Configuration Guide -

Server Connection- Disk Storage System Settings" that corresponds to the ETERNUS DX to be connec-

ted.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

Server#1

192.168.0.10

Converged Network Adapter

card WWN

10 00 00 00 C9 D0 43 DD

Step 1

through

Step 5

shown here for each Converged Network Adapter card to be installed.

Instance name

Physical address

CD4C0000

Cable tag

SERV1_SLOT0 to SWITCH_1_port0

ESX

P3AM-4772-11ENZ0