Fujitsu SPARC Enterprise M5000 Product Notes - Page 27
Browse online or download pdf Product Notes for Server Fujitsu SPARC Enterprise M5000. Fujitsu SPARC Enterprise M5000 44 pages. Rci build procedure
Also for Fujitsu SPARC Enterprise M5000: Features Manual (30 pages), Supplementary Manual (36 pages), Getting Started Manual (4 pages)
Print Page
XCP Issues and Workarounds (Continued)
TABLE 6
ID
Description
RTIF1-
When you set the XSCF user account name to
070914-006
the maximum 32 characters, you can log in,
but then, when you execute the XSCF Shell or
operate the XSCF Web, "Permission denied"
occurs.
RTIF1-
The CLI 'showldap -c' (which displays
070914-019
current LDAP certificates) will show proper
data only when used with the same user
account that had originally provided certificate
information using 'setldap -c'. Any other
user account will generate "Permission denied"
error. Similarly, the XSCF Web's LDAP
Configuration pop-up screen will display no
data, when a different user account is used.
RTIF1-
On the User Account setting page on the User
070914-020
Manager screen, after the password change
resulted in "Change Password Error," when
you click on the REFRESH button, there
appears the error message "No user. The
request is aborted."
RTIF1-
During the Open BootPROM process, when
070914-021
you power off the domain, the error log of
Domain hang-up detected (level3) may be
registered.
RTIF1-
When you specify the domain ID or XSB
070914-023
number which are not supported on the
machine, there appears the parameter error
message.
RTIF1-
The XSCF firmware monitors itself and if it
detects any inconsistencies, it forces an XSCF
071102-001
reboot.
RTIF1-
The snmp daemon might quit.
071102-002
RTIF1-
After using the addfru(8) or replacefru(8)
071116-001
command to hotplug a CMU, further DR
operations might fail with a misleading
message regarding the board being
unavailable for DR.
Workaround
Use up to 31 characters to set the XSCF user
account name.
Use the same user account for all LDAP
display or configuration operations, for both
CLI and XSCF Web.
To change the password, select User Manager
on the Menu again.
This error log can be safely ignored.
To specify the available domain ID or XSB
number on the machine.
There is no workaround. Allow the XSCF Unit
to finish rebooting. It returns to normal
operation within approximately 5 minutes.
To restart the snmp daemon, issue the
command setsnmp enable.
When performing the addfru(8) and
replacefru(8) commands, it is mandatory to
run diagnostic tests. If you forget to run the
diagnostic tests during
addfru(8)/replacefru(8) then either run
testsb(8) to test the CMU or remove the
CMU/IOU with the deletefru(8) command
and then use the addfru(8) command with the
diagnostic tests.
SPARC Enterprise M4000/M5000 Servers Product Notes
17