Fujitsu fi 5750C - Document Scanner Cleaning And Maintenance - Page 6

Browse online or download pdf Cleaning And Maintenance for Scanner Fujitsu fi 5750C - Document Scanner. Fujitsu fi 5750C - Document Scanner 39 pages. Image scanner
Also for Fujitsu fi 5750C - Document Scanner: Getting Started (40 pages), Installation Procedures Manual (7 pages), Installation Procedures Manual (9 pages), Installation Procedures (3 pages), Specifications (2 pages), Getting Started Manual (42 pages), Brochure & Specs (2 pages), Instruction Manual (11 pages), Consumable Replacement And Cleaning Instructions (19 pages), Cleaning Instructions (2 pages), Cleaning Instructions (2 pages)

Print Page

CONTENTS

Introduction

1 NAMES AND FUNCTIONS OF PARTS

2 BASIC SCANNER OPERATION

3 SCANNING VARIOUS TYPES OF DOCUMENTS

4 DAILY CARE

4.1 Cleaning materials and locations requiring cleaning

4.2 Cleaning the ADF

5 REPLACING CONSUMABLES

6 TROUBLESHOOTING

7 ONLINE SETUP

8 DOCUMENT SPECIFICATION OF ADF

9 OPTIONS

10 SCANNER SPECIFICATIONS

Appendix

4.2 Cleaning the ADF (Continued from the previous page)

4.2.1 Cleaning the ADF using with a cloth moisten with Cleaner F1

(Continued from the previous page)

Cleaning the Pick roller set

1. Pressing on the ADF button pull slowly towards you the ADF to open and, remove the ADF paper chute from the scanner.

2. Open the pick roller cover. Remove the pick rollers (2 rollers) from the shafts and use a clean cloth with the F1 Cleaner to clean.

3. After cleaning the rollers, re-install them in their proper positions in the shafts.

4. Close the pick roller cover and attach the ADF paper chute.

5. Holding the upper center portion of the ADF, gently close it until the ADF button latches and clicks close.

Cleaning the Feed rollers

1. Open the ADF while pushing the ADF button. If you open the ADF when the indication of the Function No. display is "P" or "0", the

Feed rollers will not rotate even if you try operating the scanner as in step 2 below.

2. Hold a lint-free dry cloth moistened with the Cleaner F1 against the feed rollers.

3. Hold down both the "Send to" and "Scan" buttons on the operator panel. The Feed rollers start rotate a little. For details on locations of

the "Send to" and "Scan" buttons, refer to

4. Perform 7 times the step 3 (the Feed rollers will rotate one full turn). Repeat this cleaning process until the rollers get completely

clean, otherwise any dirt on them can adversely affect the image pick-up performance.

5. Once you have cleaned the Feed Rollers, close the ADF by pushing it gently forward until the ADF button latches and clicks close.

CAUTION

-Be careful not to pinch your fingers with the ADF cover.

-The glass surface inside the ADF becomes hot during the operation of the scanner. Take care not to touch the glass.

"1.2 Functions of the operator

panel".

| 2 |