Fujitsu fi-5015 Getting Started - Page 10

Browse online or download pdf Getting Started for Scanner Fujitsu fi-5015. Fujitsu fi-5015 12 pages.

Print Page
Fujitsu fi-5015 Getting Started
2.3 Connecting the Scanner to
Your PC
Follow the procedure below to connect the USB cable.
1. Connect the USB interface cable to the USB
interface connector.
2. Connect the other end of the USB interface
cable to the PC.
•
Be sure to use the USB cable which
ATTENTION
comes as an accessory with this scan-
ner. Correct operation with commercially
available cables is not guaranteed.
•
When connecting to an USB hub, use
the first stage USB hub that is closest to
the computer. If you use the second or
later hub stages, the scanner may not
operate correctly.
•
If you connect the scanner with USB 2.0,
it is required that the USB port and Hub
are compliant with USB 2.0. The scan-
ning speed may slow down if it is con-
nected with USB1.1.
3. Press the "I" side of the main power switch to
turn on the scanner.
4. Press the power button to turn ON the scanner.
Your scanner will be automatically detected.
For Windows 2000:
When [Digital Signature not Found] appears,
click [Yes].
The installation of the scanner is completed.

2.4 Confirming Installation

This section explains how to check the operation of the
installed scanner driver by using ScandAll PRO.
Make sure that the scanner driver is installed properly,
following the procedure below.
■ Checking the Operation of the

Scanner Driver

1. Load the document on the scanner.
2. Launch ScandAll PRO.
From the [start] menu, select [All Programs] ->
[Fujitsu ScandAll PRO] -> [ScandAll PRO].
⇒
ScandAll PRO starts up.
3. In ScandAll PRO, select [Tool] on the menu,
and then select [Preferences].
⇒
The [Setup] dialog box appears.
4. On the [Scan] tab, select a driver.
To check the operation of TWAIN, select
[TWAIN].
To check the operation of ISIS, select [ISIS].
5. Click the [OK] button to close the [Setup] dialog
box.
6. In ScandAll PRO, select [Scan] on the menu,
and then select [Select Scanner].
7. Select a scanner in the displayed dialog box.
To use TWAIN:
Select [FUJITSU fi-5015C], and then click the
[Select] button.
To use ISIS:
Select [Fujitsu fi-5015C] and then click the
[Select] button.
8. Select [Scan] on the menu, and then select
[Scan Settings].
10