Fujitsu FI-5015C Getting Started - Page 4
Browse online or download pdf Getting Started for Scanner Fujitsu FI-5015C. Fujitsu FI-5015C 26 pages. Image scanner
Also for Fujitsu FI-5015C: Brochure & Specs (2 pages), Getting Started (24 pages), Consumable Replacement And Cleaning Instructionsmable Replacement And Cleaning Instructions (10 pages)
Print Page
INTRODUCTION
Thank you for purchasing the fi-5015C Color Scanner.
This document describes how to use fi-5015C and basic
operation methods. Before you start using fi-5015C be
sure to thoroughly read this manual to ensure correct
use.
The "Operator's Guide" stored on the Setup CD Rom
provides useful and detailed information on Operations
when you would like to use advanced features, Daily
Care for maintenance of the scanner, and Replacing
Consumables to maintain conditions for smooth scan-
ning. Please also read the Operator's Guide for further
information.
■ Regulatory Information
FCC declaration
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
located.
•
Consult your dealer or an experienced radio/TV
technician.
FCC warning: Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
The use of a shielded interface cable is
NOTICE
required to comply with the Class B limits
of Part 15 of FCC rules.
The length of the AC cable must be 3
meters (10 feet) or less.
ii
Canadian DOC Regulations
This digital apparatus does not exceed the Class B
limit for radio noise emissions from digital
apparatus set out in the Radio interference
Regulations of the Canadian Department of
Communications.
This Class B digital apparatus complies with
Canadian ICES-003.
Le présent appareil numérique n'émet pas de
parasites radioélectriques dépassant les limites
applicables aux appareils numériques de la classe
B et prescrites dans le Règlement sur le brouillage
radioélectrique dictées par le Ministère des
Communications du Canada.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
Bescheimigung des Herstellers /
Importeurs
Für den fi-5015C wid folgendes bescheinigt:
•
In Übereinsstimmung mit den Bestimmungen
der EN45014(CE) funkentstört
•
Maschinenlärminformationsverordnung
3.GPSGV: Der höchste Schalldruckpegel beträgt
70 dB (A) oder weniger, gemäß EN ISO 7779.
International E
NERGY
E
As an
NERGY
Partner, PFU LIMITED has
determined that this product
E
meets the
NERGY
guidelines for energy efficiency.
The International
S
®
TAR
Office Equipment Program is an
international program that promotes energy
saving through the penetration of energy efficient
computers and other office equipment. The
program backs the development and
dissemination of products with functions that
effectively reduce energy consumption. It is an
open system in which business proprietors can
participate voluntarily. The targeted products are
office equipment such as computers, monitors,
printers, facsimiles, copiers, scanners, and
multifunction devices. Their standards and logos
are uniform among participating nations.
®
S
Program
TAR
S
®
TAR
S
®
TAR
E
NERGY