Fujitsu M3093EX Operator's Manual - Page 41

Browse online or download pdf Operator's Manual for Scanner Fujitsu M3093EX. Fujitsu M3093EX 50 pages. Departmental document scanner
Also for Fujitsu M3093EX: Brochure (2 pages), Installation Procedures (3 pages), Brochure & Specs (2 pages), Cleaning Instructions Manual (12 pages)

Print Page

(2) Activating the continuous operation test

Open the ADF and close it again. If no document is loaded on the ADF within five sec-

onds after closing the ADF, the image scanner runs in flatbed mode. If documents are

loaded on the ADF within five seconds after closing the ADF, the image scanner continu-

ously feeds the document from ADF. Once the image scanner start reading documents in

the flatbed mode, it does not feed documents from ADF even if documents are loaded on

the ADF.

(3) Ending the test in flatbed mode

To stop the carrier movement in flatbed mode, open the ADF cover. If the ADF cover is

opened, the POWER lamp starts blinking immediately after the carrier returns to the home

position.

(4) Ending the test in ADF mode

If the ADF document hopper is empty, feeding documents from the ADF ends. To restart

feeding, open the ADF cover and close it again. Then load documents on the ADF docu-

ment hopper within five seconds after closing the ADF cover.

(5) LED status on error

If an error occurs during the test, the LED indicates as shown in table B.1.

If paper is jammed in the ADF, remove the jam and close the ADF cover. The CHECK

lamp stops blinking about three seconds after closing the ADF cover. To feed the docu-

ment from ADF, open and close the ADF cover.

Errors

Paper jam

Carrier unit error

Optical system error

Motor fuse failure

Lamp fuse failure

B – 2

Table B.1 LED at an error

POWER lamp

Blink

READ lamp

CHECK lamp

Off

Blink