Fujitsu PA03360-B505 - ScanSnap S500 Getting Started - Page 16
Browse online or download pdf Getting Started for Scanner Fujitsu PA03360-B505 - ScanSnap S500. Fujitsu PA03360-B505 - ScanSnap S500 25 pages. Color image scanner
Also for Fujitsu PA03360-B505 - ScanSnap S500: Brochure & Specs (2 pages)
Print Page
4. Troubleshooting
This chapter describes common problems during the usage of ScanSnap and how to remedy them.
4.1. Troubleshooting Checklist
Before you ask for repair service, please check the following items.
If you cannot solve the problem even after checking the following items, contact the store where you purchased the
scanner, or contact an authorized FUJITSU scanner service provider.
Symptom
The scanner cannot be turned
on.
Scanning does not start.
Vertical lines appear in the
scanned image.
14 |
Check This Item
Are the AC/USB cable and AC adapter
connected correctly?
Is the Paper chute cover closed? (The
scanner's power supply is controlled by
closing/opening the Paper chute cover.)`
Is Windows normally started up?
(This scanner's power is controlled by turning
on/off the computer.)
Did you push the [POWER] button to turn off
the scanner? (The scanner can be turned off by
pressing [POWER] button when the paper
chute cover is opened.)
Is the USB cable properly connected?
Does the
LED light blink repeatedly?
Is ScanSnap Manager started?
(If ScanSnap Manager is started successfully,
the "ScanSnap Manager" icon
the task tray.)
Is ScanSnap Manager running normally?
(If ScanSnap Manager is not running normally,
the "ScanSnap Manager" icon in the task tray
is displayed as
.)
Is the "Scan and Save Settings" window still
displayed?
Is the inside of the ADF dirty?
Correctly connect the AC/USB cable and AC
adapter.
Disconnect the AC adaptor/cable and reconnect
them again.
(Note: Please wait at least 5 seconds before
reconnecting the AC cable.)
Open the Paper chute cover.
Please wait until Windows has started up
completely. The
Windows is starting up or the scanner is in low
power mode.
Press the [POWER] button on the scanner.
Correctly connect the USB cable. (When a hub is
used, check the hub's power supply.)
Disconnect the AC adaptor/cable and reconnect
them again.
(Note: Please wait at least 5 seconds before
reconnecting the AC or USB cable.)
If the "ScanSnap Manager" icon is not displayed,
on the [Start] menu, select [Programs] -
S
[ScanSnap Manager] - [ScanSnap Manager] to
appears on
start up ScanSnap Manager.
Perform the following procedure:
1. Perform "Scan for hardware changes" or
"Refresh" from Device Manager. (*1) If the
situation does not improve, perform step 2.
2. Disconnect and re-connect the AC cable and
the AC adapter (Please wait at least 5 seconds
before turning on the power again.). If this
does not change the state, please perform step
3.
3. If an USB hub is used, directly connect
ScanSnap to your PC. If this does not change
the state, please perform step 4.
4. If your PC has multiple USB ports, connect
ScanSnap with other port(s). If this does not
change the state, perform step 5.
5. .Restart your PC.
If none of the above operations resolve the
problem, uninstall and re-install ScanSnap
Manager following the procedure given at (*2)
Close the "Scan and Save Settings" window, and
scan the document.
Clean the inside of the ADF following the
instructions in "5. Daily Care".
Remedy
LED may turn off when