Fujitsu S500M - ScanSnap - Document Scanner Getting Started - Page 11
Browse online or download pdf Getting Started for Scanner Fujitsu S500M - ScanSnap - Document Scanner. Fujitsu S500M - ScanSnap - Document Scanner 24 pages. Color image scanner for macintosh
Also for Fujitsu S500M - ScanSnap - Document Scanner: Installation Procedures (3 pages), Brochure & Specs (2 pages)
Print Page
4. Troubleshooting
This chapter describes common problems during the use of ScanSnap and how to solve them.
4.1. Troubleshooting Checklist
Before you ask for repair service, check again using the table below.
If you cannot solve the problem by doing the following, contact the store where you purchased the scanner, or
contact an authorized FUJITSU scanner service provider.
Symptom
The scanner cannot be turned on.
Scanning does not start.
Vertical lines appear in the scanned
image.
The scanned image of the document
shifts or is distorted.
The image scanned is too light or too
dark.
Check This Item
Are the AC/USB cable and AC adapter
connected correctly?
Is the Paper chute closed? (The scanner's
power supply is controlled by
closing/opening the Paper chute cover.)
Is Mac OS running?
(The scanner's power supply is controlled
by turning on/off the computer.)
Did you push the [POWER] button to turn
off the scanner? (The scanner can be turned
off by pressing the [POWER] button when
the paper chute is open.)
Is the USB cable properly connected?
Does the
LED light blink repeatedly?
Is ScanSnap Manager started?
(If ScanSnap Manager is started
successfully, the "ScanSnap Manager" icon
and a triangle underneath appear on the
Dock menu.)
Is ScanSnap Manager running normally?
(If ScanSnap Manager is not running
normally, the "ScanSnap Manager" icon on
the Dock menu is inactive
Is the "Scan and Save Settings" window still
displayed?
Is the inside of the ADF dirty?
Is the document loaded correctly?
Is the "Brightness (Black and White
scanning only) setting on [Option...] of the
[Scanning] tab set to extremely Light or
Dark?
ScanSnap S500M for Macintosh Getting Started | 9
Correctly connect the AC/USB cable and
AC adapter.
Disconnect the AC adaptor/cable and
reconnect them again.(Note: Please wait at
least 5 seconds before reconnecting the AC
cable)
Open the Paper chute.
Please wait until Mac OS has started up
completely. The
while Mac OS is starting up or the scanner
is in low power mode.
Press the [POWER] button on the scanner.
Correctly connect the USB cable. (When a
hub is used, the hub should be powered.)
Disconnect the AC adaptor/cable and
reconnect them again.
If the "ScanSnap Manager" icon is not
displayed, with Finder, start ScanSnap
Manager from the location where
"ScanSnap" is installed (to start it, select
"Applications" - "ScanSnap" - "ScanSnap
Manager").
Perform the following procedure:
1. Disconnect and reconnect the AC cable
and AC adapter.
If this does not improve the situation,
.)
perform step 2.
2. If a USB hub is being used, connect the
scanner directly to your personal
computer.
If this does not improve the situation,
perform step 3.
3. Restart your personal computer.
4. If none of the above troubleshootings
solves the problem, uninstall and
re-install ScanSnap Manager.
Close the "Scan and Save Settings" window,
and scan the document.
Clean the inside of the ADF following the
instructions in "5. Daily Care."
Load the document correctly.
Adjust "Brightness" at [Scanning] -
[Option...] in the "Scan and Save Settings"
window.
Resolution
LED may turn off