Fujitsu ScanSnap FI-4110EOX2 Getting Started Manual - Page 7
Browse online or download pdf Getting Started Manual for Scanner Fujitsu ScanSnap FI-4110EOX2. Fujitsu ScanSnap FI-4110EOX2 18 pages. Color image scanner
Also for Fujitsu ScanSnap FI-4110EOX2: Installation Procedures (2 pages), Specifications (2 pages)
Print Page
1. Preparation
This chapter describes preparations you must perform
before you start using ScanSnap! product.
Don't connect the scanner to your computer
ATTENTION
before installing "ScanSnap! Driver".
If the scanner is connected before installing
ScanSnap! Driver, it will not operate
normally.
Refer to Chapter 2 for the driver installation.
1.1. Checking the Contents of the
Package
When you unpack the scanner package, make sure that all
parts are included.
Refer to the package contents list included in the scanner
package box.
1.2. Names and Functions of Parts
This section describes the names of parts and their
functions.
Front Side
Stacker
Align the stacker with
both edges at the
bottom of the scanner,
and firmly insert as far
as possible.
Duplex
Press to scan
duplex document.
Simplex
Press to scan
simplex document.
LED
Lights when scanner
is ready.
During scanning,
this LED blinks.
Operation panel
Claw
Pick arm
ADF paper chute
Insert claws into the holes at the top of
scanner body so that the ADF paper
chute reclines towards the rear of the
scanner.
Rear Side
Cover open lever
AC adapter connector
USB connector
Seal informing installation of software first
After installing the software, remove this seal.
*Attach the core on the USB cable.
About Document Specification
HINT
Please refer to "ScanSnap! fi-4110EOX2
Operator's Guide" for Document
Specification.
The ScanSnap! scanner is not provided with
ATTENTION
a power switch. To turn the scanner OFF,
disconnect the USB cable, and then
disconnect the AC cable from the power
outlet.
ScanSnap! fi-4110EOX2 Getting Started | 5