Fujitsu 200 User Manual - Page 2

Browse online or download pdf User Manual for Storage Fujitsu 200. Fujitsu 200 2 pages. Harsh environment case for pencentra 130
Also for Fujitsu 200: Specification Sheet (2 pages), User Manual (8 pages), User Manual (2 pages), User Instructions (1 pages), User Instructions (1 pages), User Instructions (2 pages)

Print Page

4. When the charged battery pack is needed,

remove the battery pack from the charger.

When the battery charger is not in use, disconnect

the DC power source.

Operational Considerations

Issues to consider when you use the FMW51BC1

battery charger are discussed as follows:

• You can insert up to two battery packs at a time

in the battery charger. When charging two

battery packs, you can insert or remove either

battery pack independently.

• The battery charger only charges one battery

pack at a time. When two battery packs are

inserted in the charger, the battery pack installed

first is charged first.

• The battery charger will indicate a full charge

level and will not begin charging the battery pack

if the battery pack charge level is 90% or higher

when the battery pack is initially inserted in the

charger. This prevents the battery pack from

being overcharged.

• When you remove the battery pack from your

pen tablet, always insert a charged battery pack

in the pen tablet to replace the one that you

removed, or apply DC power.

• The FMW51BP1, FMW29BP1, and FMW29BP2

battery packs use lithium ion battery cells which

have no "memory effect." You do not need to

discharge or "condition" the battery pack before

charging.

Battery Pack Charge Time

The approximate maximum amount of time needed

to charge a fully discharged battery pack to the 90%

level is shown in the following table. Note that when

two battery packs are installed in the charger, they

are charged sequentially (starting with the battery

pack that is installed first).

Battery Pack

3-cell

FMW51BP1

FMW29BP2

6-cell

FMW29BP1

2 of 2

Approximate

Charge Time

<2 hours

<3.5 hours

FCC Notice

This equipment has been tested and found to

comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment

generates, uses, and can radiate radio

frequency energy and, if not installed and used

in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause harmful interference to

radio or television reception, which can be

determined by turning the equipment off and on,

the user is encouraged to try and correct the

interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on a

circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/

TV technician for help.

Changes or modifications not expressly

approved by Fujitsu Personal Systems, Inc.,

could void the user's authority to operate the

equipment.

58-0664-00A