Fujitsu ETERNUS AX Series Installing - Page 3

Browse online or download pdf Installing for Storage Fujitsu ETERNUS AX Series. Fujitsu ETERNUS AX Series 9 pages. Installing a cisco nexus 9336c-fx2 switch and pass-through panel in a cabinet, for cisco nexus 9336c-fx2 switches
Also for Fujitsu ETERNUS AX Series: Quick Start Manual (8 pages)

Print Page

Installing a Cisco Nexus 9336C-FX2 switch and pass-through

panel in a Fujitsu cabinet

You can install the Cisco Nexus 9336C-FX2 switch and pass-through panel in a Fujitsu cabinet with the

standard brackets that are included with the switch.

Before you begin

You must have reviewed the initial preparation requirements, kit contents, and safety precautions.

Cisco Nexus 9000 Series Hardware Installation Guide

About this task

• For each switch, you must supply the eight 10-32 or 12-24 screws and clip nuts to mount the brackets and

slider rails to the front and rear cabinet posts.

• You must use the Cisco standard rail kit to install the switch in a Fujitsu cabinet.

Note: The jumper cords are not included with the pass-through kit and should be included with your switches.

Procedure

1. Install the pass-through blanking panel in the Fujitsu cabinet.

The Fujitsu pass-through panel kit contains the following hardware:

• One pass-through blanking panel

• Four 10-32 x .75 screws

• Four 10-32 clip nuts

a) Determine the vertical location of the switches and blanking panel in the cabinet.

In this procedure, the blanking panel will be installed in U40.

b) Install two clip nuts on each side in the appropriate square holes for front cabinet rails.

c) Center the panel vertically to prevent intrusion into adjacent rack space, and then tighten the screws.

d) Insert the female connectors of both 48-inch jumper cords from the rear of the panel and through the

brush assembly.

1. Female connector of the jumper cord.

2. Install the rack-mount brackets on the Nexus 9336C-FX2 switch chassis.

a) Position a front rack-mount bracket on one side of the switch chassis so that the mounting ear is

aligned with the chassis faceplate (on the PSU or fan side), and then use four M4 screws to attach the

bracket to the chassis.