Fujitsu ETERNUS DX200 S3 Configuration Manual - Page 9

Browse online or download pdf Configuration Manual for Storage Fujitsu ETERNUS DX200 S3. Fujitsu ETERNUS DX200 S3 13 pages. Hybrid storage systems, all-flash arrays, power synchronized unit
Also for Fujitsu ETERNUS DX200 S3: Configuration Manual Server Connection (12 pages), Configuration Manual Server Connection (12 pages), Configuration Manual (28 pages), Configuration Manual (18 pages), Setup Manual (15 pages), Safety Precautions (12 pages)

Print Page

Chapter 2

Setting Up the ETERNUS DX

2.1

Common Settings

Parameter

Transfer Rate

Frame Size

Reset Scope

Release Reservation if Chip is Reset

*1: Set the appropriate value from the following table.

Fibre Channel switch maximum

speed

16Gbit/s

8Gbit/s

4Gbit/s

*1: Specify "Auto Negotiation" for direct connections to 16Gbit/s Brocade Fibre Channel cards.

Make sure to prepare and set up Fibre Channel switches for Fibre Channel connections. For setting details,

refer to "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre Chan-

nel Switch Settings" or "Fabric OS Administrator's Guide Supporting Fabric OS".

2.1.2

Creating the Server Accessible LUN Groups (Setting the LUN Groups)

Create LUN groups for the server to access. Refer to "Connectivity Management" in "ETERNUS Web GUI User's

Guide" for details, and set the LUN groups.

Depending on the OS version, the server may not recognize the ETERNUS DX unless a LUN group is as-

signed from LUN0. In this case, assign a LUN group starting from LUN0 in ascending order.

Transfer rate setting value

16Gbit/s CA

16Gbit/s (*1)

8Gbit/s

4Gbit/s

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Setting value

See the table below (*1)

2048

I_T_L

Disable

8Gbit/s CA

8Gbit/s

4Gbit/s

P3AM-7962-08ENZ0