AEG OKO-LAVAMAT 1051 VI SENSORTRONIC Instruction Booklet - Page 8

Browse online or download pdf Instruction Booklet for Washer AEG OKO-LAVAMAT 1051 VI SENSORTRONIC. AEG OKO-LAVAMAT 1051 VI SENSORTRONIC 24 pages. The environmentally friendly washing machine

Print Page

Description of the appliance

RINSE PLUS

Can be used with all programmes except the wool programme. The

machine performs 4 rinses instead of 3.

This option is recommended for people who are allergic to detergents

and in areas where the water is very soft.

RINSE HOLD

When this button is pressed, the last rinse water is not emptied out, to

prevent the fabrics from creasing. When the programme has finished, the

corresponding pilot light on the programme progress display flashes to

indicate that the water must be emptied out.

To empty out water:

• press the START/PAUSE button

forms the spin cycle required for the type of wash selected;

• select the DRAIN programme D to empty out the water without spin-

ning.

Warning! The programme selector dial must be turned first to RESET O

and then to programme "DRAIN" D.

This option can also be selected for the wool programme: the last

rinse water is emptied out but the machine does not spin.

If the water is not emptied out, the machine automatically empties

itself after 18 hours.

SPIN SPEED

Press this button to reduce the maximum speed of the final speed proposed

by the machine for the selected programme.

The maximum spin speed for cotton is 1000 rpm, for synthetics and

wool 900 rpm and for delicates 700 rpm.

Display

The display shows the following information:

• if the programme selector dial is on the RESET O position, three flashing

dashes appear immediately after pressing the ON/OFF button to indicate

that the machine is ready to receive instructions for the required wash

programme;

• duration of the selected wash programme, calculated automatically on

the basis of the maximum recommended load for each type of fabric.

• When the programme has finished, three flashing zeros are dis-

played;

146

: after emptying, the machine per-

• delayed start, programmed using the special button (C).

The selected delay (19 hours max.) is indicated in the display. The

countdown is updated every hour, and every 5 minutes during the last

hour.

• Machine heating phase. A dot to the right of the figures in the dis-

play indicates that the machine is heating the water. During this

phase the user can therefore decide whether to use other electrical

appliances simultaneously.

• Incorrect option selection. If an option which is not compatible with

the set wash programme is selected, the message Err is displayed.

Programme progress display

By selecting the wash programme, the pilot

lights corresponding to the various phases mak-

ing up the programme come on.

After the machine has started, only the running

phase pilot light stays on. When the programme

has finished, the END

pilot light comes on.

Cancelling a programme

To cancel a programme which is running, turn the programme selector

dial to the RESET O position: three flashing dashes will be displayed.

Warning! After a programme which ends with water in the drum

(RINSE HOLD option

), turn the selector dial first to RESET O and

then to the DRAIN programme D.

Description of the appliance

PREWASH

WASH

RINSES

RINSE HOLD

DRAIN

SPIN

END

147