AEG OKO-LAVAMAT 62310 Operating Instructions Manual - Page 31

Browse online or download pdf Operating Instructions Manual for Washer AEG OKO-LAVAMAT 62310. AEG OKO-LAVAMAT 62310 40 pages. The environmentally friendly washing machine

Print Page

Disturbance

The suds in the main

wash cycle create too

much foam.

Water is leaking out

from under the wash-

ing machine.

Fabric softener is not

added, compartment

for fabric softener is

filled with water.

Washing has not been

spun, there is water left

in the drum.

Washing has not been

spun well, there is

water left in the drum.

The door cannot be

opened.

Possible cause

Probably too much washing

powder was used.

The clamp on the inlet hose

is not tight.

The inlet hose has a leak.

The lid of the suds pump is

not correctly closed.

Washing is caught in the

door.

Suction cap in the compart-

ment for fabric softener is

not correctly fitted or is

blocked.

RINSE HOLD is selected.

The soaking program has

been completed.

There is a kink in the outlet

hose.

Maximum pumping height

(drain height 1m from the

position of the machine) is

exceeded.

Suds pump is blocked.

If a siphon is connected: the

siphon is blocked.

The program has not yet

been completed (display

lamp ON/OFF lights up).

Troubleshooting

Remedy

Only use as much as the

washing powder manufac-

turer recommends.

Tighten the inlet hose.

Check the inlet hose and if

necessary replace it.

Close the lid correctly.

Abort the program, remove

the washing caught in the

door, start a new program.

Clean the detergent com-

partment, fit the suction cap

on firmly.

Deselect RINSE HOLD.

Pump out the water and set

the main wash cycle

required.

Eliminate the kink.

Please contact the customer

service, it has a retro-kit

available for pump heights

above 1m.

Switch off the machine and

pull the plug out of the

socket, clean the suds pump.

Clean the siphon.

Wait until the ON/OFF lamp

goes out.