Fujitsu ETERNUS DX80 Configuration Manual - Page 25

Browse online or download pdf Configuration Manual for Storage Fujitsu ETERNUS DX80. Fujitsu ETERNUS DX80 28 pages. Disk storage system
Also for Fujitsu ETERNUS DX80: Setup Manual (4 pages), User Manual (35 pages), User Manual (42 pages), Setup Manual (4 pages), Using Optional Products (2 pages), Configuration Manual (16 pages), Using Optional Products (2 pages), Product Introduction (19 pages), Package Contents (4 pages), Manual (4 pages)

Print Page

Chapter 8

Setting the Multipaths

8.2

Multipath Configuration using Native Multipath

8.2

Multipath Configuration using Native Multipath

"Native Multipaths" is an OS function available for HP-UX11iv3 onwards.

Native Multipaths can be used to set the I/O load balance policy (load_bal_policy) and enable ALUA

(alua_enabled).

Perform these settings to match the ETERNUS DX model and depending on whether the OS supports ALUA.

8.2.1

Set the I/O load balance policy to match the ETERNUS DX model being used as shown below. The policy set-

ting is required for all LUNs in the ETERNUS DX.

I/O load balance policy setting vs ETERNUS DX model

•

ETERNUS DX

DX60 S3/DX100 S3/DX200 S3,

DX500 S3/DX600 S3,

DX200F,

DX80 S2/DX90 S2,

DX400/DX400 S2 series,

DX8000/DX8000 S2 series

DX60/DX60 S2, DX80

Example procedure of I/O load balance policy setting

•

Setting the I/O load balance policy to "round_robin"

# scsimgr save_attr -D /dev/rdisk/disk25 -a load_bal_policy=round_robin

Execute this "load_bal_policy" setting command for all LUNs in the ETERNUS DX.

If the I/O load balance policy is "preferred_path", a priority path must be set. Set the path that is used

when the I/O load is balanced as the priority path.

•

Example procedure priority path setting

Specify the hardware path of the "Lunpath" that is to be the priority path.

# scsimgr save_attr -D /dev/rdisk/disk25 -a preferred_path=64000/0x0/0x0.0x0.0x4

000000000000000

Lunpath hardware paths can be checked using the "ioscan -m lun" and "scsimgr lun_map" commands.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX

I/O load balance policy setting

round_robin

preferred_path

P3AM-3402-14ENZ0