Fujitsu ETERNUS4000 400 Server Connection Manual - Page 17
Browse online or download pdf Server Connection Manual for Storage Fujitsu ETERNUS4000 400. Fujitsu ETERNUS4000 400 25 pages. Disk storage systems (fibre channel) for oracle solaris
Also for Fujitsu ETERNUS4000 400: Manual (28 pages), Manual (21 pages), Server Connection Manual (32 pages), Connection Manual (19 pages)
Print Page
Chapter 8
Connect the ETERNUS Disk storage system to the server with a LAN cable.
After connecting, reboot the Linux server and check that the Linux server recognizes the
ETERNUS Disk storage system LUNs.
YaST is used to set up the server. Refer to the Novell web-site for details of the setup procedure
with YaST.
8.1
When CHAP Authentication is not Used
1
2
3
4
5
6
7
8
P3AM-4152-02ENZ0
ETERNUS Disk storage systems Server Connection Guide (iSCSI) for Linux
(SUSE Linux Enterprise Server)
ETERNUS Disk Storage System Logical
Unit Recognition
Procedure
Start YaST and then run the iSCSI Initiator in Miscellaneous.
Select the "Discovered Targets" tab and click the [Discovery] button to open the
iSCSI Initiator Discovery dialog.
Set the IP address for the ETERNUS Disk storage system iSCSI port in "IP
Address".
Keep the default port number value (3260).
Check that "No_Authentification" is selected and click the [Next] button.
Check that the desired Target is visible in the "Discovered Targets" tab.
The "Connected" state of the Target should be "False" at this time.
Select the desired Target in the "Discovered Targets" tab, and click the [Log In]
button to re-open the CHAP selection dialog.
If CHAP authentication is not being used, check that "No_Authentification" is selected and
click the [Next] button.
After both path logins have completed, check that the information of the desired
Target is visible in the "Connected Targets" of the iSCSI Initiator Overview.
Make sure that "Start-Up" for the desired Target is set to "automatic" (if currently
set to "manual", select the Target and click the [Toggle Start_Up] button), then
click the [Finish] button.
17
End of procedure
Copyright 2010 FUJITSU LIMITED