Fujitsu ETERNUS8000 2200 Server Connection Manual - Page 17

Browse online or download pdf Server Connection Manual for Storage Fujitsu ETERNUS8000 2200. Fujitsu ETERNUS8000 2200 25 pages. Disk storage systems (fibre channel) for oracle solaris
Also for Fujitsu ETERNUS8000 2200: Manual (28 pages), Manual (21 pages), Server Connection Manual (32 pages), Connection Manual (19 pages)

Print Page

Fujitsu ETERNUS8000 2200 Server Connection Manual

Chapter 8

Connect the ETERNUS Disk storage system to the server with a LAN cable.

After connecting, reboot the Linux server and check that the Linux server recognizes the

ETERNUS Disk storage system LUNs.

YaST is used to set up the server. Refer to the Novell web-site for details of the setup procedure

with YaST.

8.1

When CHAP Authentication is not Used

P3AM-4152-02ENZ0

ETERNUS Disk storage systems Server Connection Guide (iSCSI) for Linux

(SUSE Linux Enterprise Server)

ETERNUS Disk Storage System Logical

Unit Recognition

Procedure

Start YaST and then run the iSCSI Initiator in Miscellaneous.

Select the "Discovered Targets" tab and click the [Discovery] button to open the

iSCSI Initiator Discovery dialog.

Set the IP address for the ETERNUS Disk storage system iSCSI port in "IP

Address".

Keep the default port number value (3260).

Check that "No_Authentification" is selected and click the [Next] button.

Check that the desired Target is visible in the "Discovered Targets" tab.

The "Connected" state of the Target should be "False" at this time.

Select the desired Target in the "Discovered Targets" tab, and click the [Log In]

button to re-open the CHAP selection dialog.

If CHAP authentication is not being used, check that "No_Authentification" is selected and

click the [Next] button.

After both path logins have completed, check that the information of the desired

Target is visible in the "Connected Targets" of the iSCSI Initiator Overview.

Make sure that "Start-Up" for the desired Target is set to "automatic" (if currently

set to "manual", select the Target and click the [Toggle Start_Up] button), then

click the [Finish] button.

End of procedure