AEG 66000I Operating And Installation Instructions - Page 24

Browse online or download pdf Operating And Installation Instructions for Refrigerator AEG 66000I. AEG 66000I 28 pages. Aeg refrigerator user manual

Print Page

Symptom

The food is too warm.

Heavy build up of frost,

possibly also on the door

seal.

The compressor does not

start immediately after

changing the temperature

setting.

Water in the bottom of

the cabinet.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light

bulb, switch off the appliance and unplug it, or disconnect from the

power supply.

Light bulb data: 220-240 V, max. 15 W

To switch off the appliance, turn the thermostat knob to position "0".

Unplug the mains plug.

To change the light bulb, undo the screw.

Press the light bulb cover as shown

and slide it backwards.

Change the defective light bulb.

Refit the light bulb cover and the

screw.

Put the refrigerator back into

operation.

Possible Cause

Temperature is not

properly adjusted.

Door was open for an

extended period.

A large quantity of warm

food was placed in the

appliance within the last

24 hours.

The appliance is near a

heat source.

Door seal is not airtight

(possibly after reversing

the door).

This is normal, no error has

occurred.

Water drain hole is

blocked.

Remedy

Please look in the "Initial

Start Up" section.

Do not leave the door open

any longer than necessary.

Turn the thermostat knob

to a colder setting tem-

porarily.

Please look in the

"Installation location" section.

Carefully warm the leaking

sections of the door seal

with a hair dryer (on a

cool setting). At the same

time shape the warmed

door seal by hand such

that it sits correctly.

The compressor starts after

a period of time.

See the "Cleaning and

Care" section.

AEG65