Brother PS-9000 User Manual - Page 42

Browse online or download pdf User Manual for Print Server Brother PS-9000. Brother PS-9000 43 pages. User manual
Also for Brother PS-9000: Brochure & Specs (6 pages), User Manual (47 pages)

Print Page

PS-9000 Settings

Below are the settings for PS-9000.

General

CD-ROM

Setup

TCP/IP

CD-ROM

Setup

Receive IP

address

automatically

IP Address

Name

Web page

LAN Interface

AUTO

Name

Web page

DHCP/BOOTP

RARP

IP Address

Factory

Default

Set up network type. Normally use in

AUTO. If the LINK LED on the hub

does not light up after the PS-9000 is

turned on, select the appropriate

network type for the hub.

Factory

Default

Enables or disables DHCP/BOOTP.

These are protocols where the IP

address is acquired from the

DHCP/BOOTP server during start up.

In order for DHCP/BOOTP to specify

the IP address of the PS-9000, a

ENABLE

DHCP/BOOTP server must exist

within the subnetwork and be

properly set up. The PS-9000 will

automatically acknowledge DHCP

and BOOTP, and use as its own

address the IP address that it

previously received as a reply.

Enables or disables RARP. RARP is a

protocol where the IP address is

acquired from the RARP server during

ENABLE

start up. In order for DHCP/BOOTP to

specify the IP address of the PS-9000,

a RARP server must exist within the

subnetwork and be properly set up.

Sets up the IP address of the PS-9000.

The value must be configured in the

0.0.0.0

format of four series of numbers

separated by decimal points, such as

"xxx.xxx.xxx.xxx".

Explanation