AEG ARCTIS Operating Instructions Manual - Page 11

Print Page

Electrical Connection

A properly installed socket outlet with earthing contact is required for

electrical connection. Electrical fuse protection must be of at least 10

ampere.

If the outlet socket is no longer accessible after installation of the

appliance, appropriate measures must be taken during electrical

installation to assure that the appliance can be disconnected from the

mains (e.g. fuse, circuit breaker, non-operate current safety-switch or

the like, with a contact opening of at least 3 mm).

1. Before initial start-up, refer to the appliance rating plate to ascertain if

supply voltage and current values correspond with those of the mains

at the installation location.

e.g.: AC 220 ... 240 V 50 Hz or

220 ... 240 V~ 50 Hz

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance at the left.

Warning: To avoid potential danger, if the mains connection lead of

this appliance is damaged, it must be replaced by our customer service

representative or a person with similar qualifications.

Warning: Under no circumstances should the appliance be connected

to electronic "power saving plugs" or to a.c.-d.c. converters which con-

vert direct current to 230 V alternating current (e.g., solar installations,

ship networks)

Installation