Brother ImageCenter ADS2500W Product Safety Manual - Page 12
Browse online or download pdf Product Safety Manual for Software Brother ImageCenter ADS2500W. Brother ImageCenter ADS2500W 20 pages. High-speed desktop document scanner
Also for Brother ImageCenter ADS2500W: Manual (16 pages), Manual (20 pages), Brochure (2 pages), Quick Setup Manual (37 pages)
Regulation
WARNING
This product must be installed near an AC power outlet that is easily accessible. In case of an
emergency, you must unplug the power cord from the AC power outlet to shut off the power
completely.
Important
• Brother cannot accept any financial or other responsibilities that may be the result of your use
of this information, including direct, special or consequential damages. There are no
warranties extended or granted by this document.
• This machine has been certified to comply with FCC standards, which are applied to the USA
only.
Federal Communications Commission (FCC) Declaration of
Conformity (USA only)
Responsible Party:
declares, that the products
Product Name: ADS-2000 and ADS-2500W
comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
12
Brother International Corporation
100 Somerset Corporate Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700
1
1