AEG OKO-SANTO 1454-6 iU Operating And Installation Instructions - Page 14
Browse online or download pdf Operating And Installation Instructions for Refrigerator AEG OKO-SANTO 1454-6 iU. AEG OKO-SANTO 1454-6 iU 28 pages. Built-in refrigerator
Print Page
Fitting the plinth
Important!
For the efficient operation of the appliance, it is important that the
original ventilation grid is used.
• For an opening height dimension
A=820 mm and a plinth height
dimension a=100 mm, the plinth
may be fitted without adjustments.
The same applies to an opening
height dimension B=870 mm and a
plinth height dimension b=150 mm.
• For plinth heights greater than
a=100 mm, b=150 mm, a cut should
be made in the plinth, 580 mm wide,
in the centre of the appliance
position, leaving a remaining height
of a=100 mm, b=150 mm.
• Attach plinth to the kitchen units.
Important!
The plinth must be positioned at a minimun distance of 25 mm from
the door.
Please check whether, after installing your appliance and especially
after reversing the door, the door seal seals right round. A badly fitting
door seal may lead to heavy frosting and result in a higher power con-
sumption (see also "What to do if ...").
Power supply
A correctly installed, earthed socket is required for the electrical supply.
The supply must have a fuse rating of at least 10 Amps. If the socket is
not accessible once the appliance is built in, the electrical installation
must include suitable means of isolating the appliance from the mains
(e.g. a fused spur).
Before initial start-up, refer to the appliance rating plate to ascertain if
supply voltage and current values correspond with those of the mains
at the installation location.
e.g.: AC 220 ... 240 V 50 Hz or
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
14
220 ... 240 V ~50 Hz
25
008