Brother MFC-5860CN Quick Setup Manual - Page 12
Browse online or download pdf Quick Setup Manual for Software Brother MFC-5860CN. Brother MFC-5860CN 34 pages. Mfc-5460cn; mfc-5860cn
Also for Brother MFC-5860CN: Setup Manual (23 pages), Quick Setup Manual (34 pages), Service Manual (9 pages)
Print Page
STEP 1
Setting Up the Machine
• DO NOT dismantle or tamper with the ink
cartridge, this can cause the ink to leak out of the
cartridge.
• Brother strongly recommends that you do not refill
the ink cartridges provided with your machine. We
also strongly recommend that you continue to use
only Genuine Brother Brand replacement ink
cartridges. Using or attempting to use potentially
incompatible inks and /or cartridges in your
machine may cause damage to the machine itself
and/or it may result in unsatisfactory print quality.
Our warranty coverage does not apply to any
problem that was caused by the use of
unauthorized third party ink and/or cartridges. To
protect your investment and guarantee your print
quality please continue to replace consumed ink
cartridges with only Genuine Brother Branded
Supplies.
7
Print quality check
1
After the cleaning cycle is finished, the LCD
shows:
Set Paper and
Press Start
2
Make sure paper is loaded in the paper tray.
Press Color Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3
Check the quality of the four color blocks on the
sheet.
(black/ yellow/ cyan/ magenta)
Improper Setup
Avoid touching the printed surface of the
paper immediately after printing, the surface
may not be completely dry and may stain your
fingers.
10
4
The LCD shows:
Is Quality OK?
1.Yes 2.No
5
Do one of the following:
If all lines are clear and visible, press 1
(Yes) on the dial pad to finish the quality
check.
If you can see missing short lines, press 2
(No) on the dial pad and go to step 6.
OK
6
The LCD asks you if the print quality is OK for
black and color. Press 1 (Yes) or 2 (No) on the
dial pad.
Black OK?
1.Yes 2.No
Color OK?
1.Yes 2.No
After pressing 1 (Yes) or 2 (No) for both black
and color, the LCD shows:
Start Cleaning?
1.Yes 2.No
7
Press 1 (Yes), the machine will then start
cleaning the colors.
8
After cleaning is finished, press Color Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 3.
8
Choosing your language
(Canada only)
1
Press Menu, 0, 0.
2
Press a or b to choose your language
(English or French) , and then press OK.
Local Language
English
3
Press Stop/Exit.
Poor