For Wireless Network Users
One-push Setup using
20
WPS or AOSS™
(Windows
Macintosh)
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your access point/router.
If you began the configuration from step 6 on
page 7, go to d.
All other users go to c.
c
On your machine, press Menu.
Press a or b to choose Network and press
OK.
d
Press a or b to choose WPS/AOSS and press
OK.
When Enable WLAN? is displayed, press OK
to accept.
This will start the wireless setup wizard.
Note
If your wireless access point/router supports WPS
(PIN Method) and you want to configure your
machine using the PIN (Personal Identification
Number) Method, see Configuration using the
PIN Method of Wi-Fi Protected Setup in the
Network User's Guide.
e
When the LCD shows Start WPS or AOSS,
press the WPS or AOSS™ button on your
wireless access point/router. See the user's
guide of your wireless access point/router for
instructions.
Then press OK and your machine will now
automatically detect which mode (WPS or
AOSS™) your wireless access point/router
uses and try to connect to your wireless
network.
26
®
and
f
A connection result message appears for
60 seconds on the LCD and a wireless LAN
report will automatically be printed.
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 27.
Wireless setup is now complete. A four
level indicator at the upper right of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step 21.
®
For Windows
Users:
Now go to
Page 29
For Macintosh Users:
Now go to
Page 32
Print Page