TROUBLESHOOTING
If any problems occur, refer to the following to resolve them.
Operation
1
Select the first pattern.
2
Press the pattern connection key.
3
Specify the reference point for connecting the pattern.
4
Begin embroidering the first pattern.
5
Finish embroidering the first pattern.
6
Start detecting marks (2 locations).
7
Finish detecting marks.
8
Rehoop the fabric.
9
Select the second pattern.
10 Specify the reference point for connecting the pattern.
11 Start detecting marks (2 locations).
12 Finish detecting marks.
13 Remove the two stickers.
14 Specify the reference point for connecting the pattern.
15 Begin embroidering the second pattern.
16 Finish embroidering the second pattern.
17 Start detecting marks (2 locations).
18 Finish detecting marks.
19 Rehoop the fabric.
20 Select the third pattern.
21 Specify the reference point for connecting the pattern.
22 Start detecting marks (2 locations).
23 Finish detecting marks.
24 Remove the two stickers.
25 Specify the reference point for connecting the pattern.
26 Begin embroidering the third pattern.
27 Finish embroidering the third pattern.
36
Operation: No. 8 & 19
Issue: When rehooping the fabric, a sticker peels off
the fabric.
Solution: The patterns cannot be connected. Restart
the procedure from the beginning.
Operation: No. 8, 11, 19 & 22
Issue: The next pattern to be embroidered and the
centers of the large circles on the stickers do not fit
within the embroidering area.
Solution1: Change the embroidery frame to a larger
one.
Solution2: Reposition the stickers so that they fit
within the embroidering area. With the embroidery
frame remaining attached to the machine, select the
next pattern, and then continue with the procedure in
"CHANGING THE POSITION OF A STICKER" on
page 22.
Operation: No. 10 & 21
Issue: You wish to change the selected reference
point.
Solution: The selected reference point can be
changed. For details, refer to "CHANGING THE
REFERENCE EDGE AND REFERENCE POINT FOR
CONNECTING THE NEXT PATTERN AFTER A
PATTERN HAS BEEN EMBROIDERED" on page 29.
Operation: No. 16
Issue: The pattern was embroidered before the
reference point for connecting the patterns was
selected.
Solution: With the embroidery frame remaining
attached to the machine, press
continue to the last stitch. Start sewing, and then
immediately stop. Press
reference point. Finish embroidering.
, and then
, and then select the
Print Page