Fujitsu Stylistic 3400 Installation Manual

Browse online or download pdf Installation Manual for Tablet Fujitsu Stylistic 3400. Fujitsu Stylistic 3400 1 pages. Wall-mount cradle
Also for Fujitsu Stylistic 3400: User Manual (3 pages), Installation Manual (4 pages), User Manual (2 pages), Operating Instructions (1 pages), Installation And User Manual (8 pages), Assembly And Use Instructions (4 pages)

Print Page
Fujitsu Stylistic 3400 Installation Manual
FMW42RC1
Radio Antenna Cover Kit

Installation Guide

Stylistic 3400
These instructions provide details on assembling
and installing the Radio Antenna Cover Kit for the
Stylistic 3400 pen tablet.
The antenna cover should be installed when most
types of antennae protrude from a radio PC Card.
The cover provides a rigid cap over the antenna to
prevent damage during everyday use.
The antenna cover was specifically tested with Symbol
TM
TM
Proxim
, BreezeCom
possible that certain other antennae will protrude too far
from the system to fit within the antenna cover.
Assembling the Radio Antenna Cover Kit
The Radio Antenna Cover Kit consists of the
following parts:
• Plastic Hood
• Plastic Base
• Two black screws
• One tapping screw
To assemble the radio antenna cover, place the
hood atop the base as illustrated in Figure 1. Make
sure the positioning tab is on the inside of the
hood. Secure the two pieces with the tapping
screw by inserting it through the hole in the base
into the standoff inside the hood.
Installing the Radio Antenna Cover
To attach the radio antenna cover to the pen tablet,
perform the following steps.
1. Position the antenna cover in relation to the
back of the pen tablet as shown in Figure 2.
2. If caps are present over the mounting holes,
remove them with a small screwdriver, or
similar tool.
®
Symbol
, Proxim
3/00
Note
®
TM
, and AiroNet
radios; it is
TM
TM
TM
, BreezeCom
, and AiroNet
Stylistic 3400 is a trademark of Fujitsu PC Corporation. © 2000 Fujitsu PC Corporation
3. Insert the antenna cover tabs into the two tab slots
on the pen tablet.
4. Insert the two black screws through the holes in the
hood and secure them to the pen tablet.
Standoff
,
0
Base
Figure 1. Assembling the Radio Antenna Cover
0
Figure 2. Installing the Radio Antenna Cover
are trademarks or registered trademarks of their respective companies.
FUJITSU PC CORPORATION
Positioning
Tab (inside)
Tapping Screw
Tab Slots
Mounting
Hole
PC Card
Tab
Slot
58-0715-00A
Hood