Fujitsu STYLISTIC Q509 User Manual - Page 5
Browse online or download pdf User Manual for Tablet Fujitsu STYLISTIC Q509. Fujitsu STYLISTIC Q509 28 pages.
Print Page
Changes or modifications not expressly
approved by Fujitsu could void this user's
authority to operate the equipment.
FCC NOTICES
Notice to Users of Radios and Television
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generate s, u se s, an d ca n radi at e radi o
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet that is
on a different circuit than the receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Shielded interconnect cables must be employed
with this equipment to ensure compliance with
the pertinent RF emission limits governing this
device.
Notice to Users of the US Telephone Network*
Your Stylistic maybe supplied with an internal
modern which complies with Part 68 of the FCC
rules. On this Tablet PC is a label that contains
the FCC Registration Number and the Ringer
Equivalence Number(REN) for this equipment
*For model with modern only
iv
among other information. If requested the user
must provide their telephone company with the
following information:
1. The telephone number to which the
Tablet PC is connected.
2. The Ringer Equivalence Number(REN)
for this equipment.
3. That the equipment requires a standard
modualar jack type USOC RJ-11C which
is FCC Part 68 compliant.
4. The FCC Registration Number.
This equipment is designed to be connected
to the telephone network or premises wiring
using a standard modular jack type USOC
RJ-11C which is FCC Part 68 68 compliant
and a line cord between the modem and the
telephone network with a minimum of 26AWG.
The REN is used to determine the number
of devices that you may connect to your
telephone line and still have all of those
devices ring when your number is called. Too
many devices on one line may result in failure
to ring in response to an incoming call. In
most, but not all, areas the sum of the RENs
of all of the devices should not exceed five(5).
To be certain of the number of devives you
may connect to your line, as determined by the
RENs, contact your local telephone company.
I f t h i s e q u i p m e n t c a u s e s h a r m t o t h e
telephone network your telephone company
may discontinue your service temporarily. If
possible, they will notify you in advance. If
advance notice is not practical they will notify
you as soon as possible. You will also be
advised of your right to file a complaint with
the FCC.
This fax modem also complies with fax branding
requirements per FCC Part 68.
Your telelphone company will probably ask
you to disconnect this equipment from the
telephone network until the problem is
corrected and you are sure that the equipment
is not malfunctioning.