Fujitsu T5010 - LifeBook Tablet PC Restoration Manual - Page 2
Browse online or download pdf Restoration Manual for Tablet Fujitsu T5010 - LifeBook Tablet PC. Fujitsu T5010 - LifeBook Tablet PC 2 pages. Rubber base cover
Also for Fujitsu T5010 - LifeBook Tablet PC: Getting Started (2 pages), Datasheet (6 pages), Bios Manual (29 pages), User Manual (8 pages), Getting Started (13 pages), Instructions (4 pages)
Print Page
16.
"Warning All DATA on the Hard Disk will be completely erased!!!" will appear.
Select [OK]. The partition creation process will begin.
17.
"3. Restoring Factory Image to hidden partition" will be in bold with the message
"Please insert the Recovery Disk#1 into the optical drive". Insert
and click [Next] to proceed. In some cases, you may be prompted to "Insert
the Recovery Disc #2", depending upon the size of the Recovery Image.
18.
After completion, the tool will automatically go to the next step to restore the
image back to c:\ drive.
19.
When restoration is complete, you will see the message "Restoration has been
completed. Click [OK] to reboot the computer." Click [OK].
Windows Initialization:
1.
Select a language in the "Set Up Windows" dialog, if necessary, then click [Next].
2.
Follow the instructions that appear.
3.
When Windows desktop is loaded, make sure that Wireless LAN switch is On (refer
to the system user's guide for exact location) before executing the ClickMe! utility.
4.
The first time you boot up your system, you will see a "Primary Settings for
the PC" window. This window explains the installations which will be
performed by the ClickMe! utility. Click [Execute]. ClickMe! will begin
installing.
5.
If after clicking the button you receive a "User Account Control" window,
you will be asked for permission to continue. Click [Yes] to continue. If you
cancel the operation, a Click Me! icon will appear on your desktop for later
installation.
Additional drivers and 3rd party applications
Some drivers and 3rd party applications are not included in the recovery image. You will
need to install them from the discs supplied with your system.
Installation from Drivers and Applications Restore (DAR) disc:
1.
Insert the DAR disc in your DVD drive.
2.
Select [Run Setup.exe] in "AutoPlay" dialog. If the "AutoPlay" dialog doesn't appear,
double-click on Setup.exe in the root folder of the DAR disc.
3.
Click [Allow] in "User Account Control" dialog, then click [Continue].
4.
Review the End User License Agreement. Select "I Agree", then click [Next].
5.
Click [Select All], then click [Install Selected Subsystems].
6.
After the components are installed, click [OK].
7.
Click [OK] to reboot your system. You must save and close all of your documents at
this point.
8.
After the system has rebooted, start the DAR disc again following steps 1-4.
9.
Review the list of the available components. Select and install the applications
marked in green by clicking [Install Selected Subsystems] button.
Please note that some components are optional and may not be installed in the system.
Installation from 3rd party discs:
Some of the applications might be provided on separate discs with your system in the box.
1.
Insert a disc in your DVD drive.
2.
Start the installation (typically by clicking Setup.exe)
3.
Follow the installation wizard.
Recovery Disc#1