Fujitsu CREMSON MODULAR STARTERKIT User Manual - Page 11

Browse online or download pdf User Manual for Motherboard Fujitsu CREMSON MODULAR STARTERKIT. Fujitsu CREMSON MODULAR STARTERKIT 36 pages.

Print Page

3 Getting Started

Make sure you have Softune Workbench for FR and the additional tools (e.g. the

flashprogrammer) installed on your PC and the evaluation board is ready to use. Refer to

Chapter 2 for details on the hardware and software installation.

If you have a system with the MB91F362 CPU module, you can not use the monitor

debugger. Instead, you have to program the application to the embedded flash. Therefore,

the provided examples are already linked for the embedded flash area of the MB91F362

(08:0000...0F:FFFF).

Creating applications for this board configuration could look like this :

1. Modify an existing project for the F362 CPU board and the GDC subboard

2. Compile&Link (Build) the project to create a valid loadmodule for the embedded flash

3. Use the MB91360 flash programmer tool to program the embedded flash

4. Test the application in stand-alone mode and continue at step 1.

If you have a system with the MB91F369 CPU module, you are able to use the monitor

debugger of Softune workbench. Hence, the examples are linked for the additional

debugging RAM of the F369 CPU-module (80:0000...8F:FFFF). Your application will be

downloaded to the debugging RAM automatically by starting the debugger.

Alternatively, you can also program the application to the embedded flash of the MB91F369

to create a stand-alone application which starts immediately after a reset. To do so, you

have to re-link the application to the internal flash area (08:0000..0F:FFFF).

Creating applications for this board configuration could look like this :

1. Modify an existing project for the F369 CPU board and the GDC subboard

2. Compile&Link (Build) the project to create a valid loadmodule for the ext. RAM

3. Start the debugger to download the application to the ext RAM

4. Test and debug the application in the debugger

5. Return to the development area of Softune Workbench to make changes

6. Continue at step 2 until your project has reached a stable stage

7. Change the linker settings for internal flash (see Appendix)

5. Use the MB91360 flash programmer tool to program the embedded flash

6. Test the application stand-alone

7. Change the linker-settings and continue at step 1. if necessary

Make sure to not overwrite the "security vector" (0x0FFEF4) – see hardware manual

Use the provided templates to make sure the sections are located correctly

Cremson Modular Starterkit

Chapter 3 Getting Started

- 11 -