Fujitsu CREMSON MODULAR STARTERKIT User Manual - Page 29

Browse online or download pdf User Manual for Motherboard Fujitsu CREMSON MODULAR STARTERKIT. Fujitsu CREMSON MODULAR STARTERKIT 36 pages.

Print Page

Checklist for project configuration :

•

Make sure, the corect Target MCU ("Project – Setup Project - MCU" menu)

MB91F369 or MB91F362 is selected as the target MCU device.

•

Use the correct linker settings as outlined above depending on your target MCU and

the target area (embedded flash or external debugging RAM).

•

Make sure to not overwrite the "security vector" (0x0FFEF4) – see hardware manual.

•

Use the provided templates to make sure the sections are located correctly.

•

Always check the "map file" (use the context menu in the project-view and select

"open list file") to see the used sections and addresses !

7.3 Starterkit limitations

If creating new projects, be sure not to use the following functions, which are reserved for

the Starterkit:

MB91F369 CPU-Board :

< Chip Selects :

CS0 is used for the external debugging RAM

CS2 is used for the external flash

CS3, CS4, CS5 are used for the graphic controller

< Memory area 0x0F:4000...0xF7:FFFF (embedded flash) is used by debugging kernel

< Memory area 0x9F:E000...0x9F:FFFF (external RAM) is used by debugging kernel

< Port N used for LEDs

< UART0 used for monitor debugger and flash programming

< External Interrupt 0 (used for Abort function)

MB91F362 CPU-Board :

< Chip Selects :

CS2 is used for the external flash

CS3, CS4, CS5 are used for the graphic controller

< Port J used for LEDs

< UART0 used for flash programming only

Cremson Modular Starterkit

Chapter 7 . Appendix

- 29 -