Fujitsu F2MC-16FX Series User Manual - Page 23

Browse online or download pdf User Manual for Motherboard Fujitsu F2MC-16FX Series. Fujitsu F2MC-16FX Series 34 pages.

Print Page

6. Check that the Reset LED is off. Otherwise change the DTR polarity (JP35) and check

the power supply voltage.

Start the tool "Fujitsu Flash MCU Programmer for FMC16FX" software and follow the

instructions:

7. The software now automatically writes a flash loader to the microcontroller ("Download"),

does a blank check and erases the Flash memory if necessary. After that the user

application is programmed to the embedded Flash memory ("Program & Verify").

If the programming sequence has ended successfully, you will receive the output "It all

ended normally completely".

9. After programming the Flash-ROM, switch off the power supply and set back the mode

according to the usage of the application, e.g.:

10. Power on the board. The user application is started directly.

Downloaded from

Elcodis.com

electronic components distributor

Chapter 4 Programming the internal Flash memory

MB96F326R

Figure 4-1: Settings for Automatic Mode

MD0 MD1 MD2 nc

Dip-Switch S2

(Run mode)

SK-96320-80PMC User Guide

OFF

- 23 -

FMEMCU-UG-960010-12