Fujitsu F2MC-8FX Series Application Note - Page 19

Browse online or download pdf Application Note for Motherboard Fujitsu F2MC-8FX Series. Fujitsu F2MC-8FX Series 23 pages. 8-bit microcontroller
Also for Fujitsu F2MC-8FX Series: Operation Manual (20 pages), Application Note (12 pages), Setup Manual (18 pages), Setup Manual (19 pages), Setup Manual (30 pages), Application Note (20 pages), Application Note (21 pages), Operation Manual (21 pages), Setup Manual (23 pages), User Manual (24 pages), Setup Manual (17 pages)

Print Page

MB2146-09 – Installation Guide

Chapter 4 Setting up the Emulation Software

4.2.2 Optimization of response speed during debugging

The communication speed of user system and MB2146-09 change by the operating

frequency of the target microcontroller. When the operating frequency is reduced,

especially in the sub clock mode, communication speed is also reduced. In this case,

optimize the communication speed. The function increasing the operating frequency

automatically is called clock-up mode. The default is ON at that time.

Also, this setting is performed at the setup wizard or [Setup] -> [Debug Environment]

-> [Debug Environment...] -> [Response speed] tab.

Note:

When the clock-up mode is used, the operating frequency is changed automatically

at breaking. If the failure is caused by changing the operating frequency, disable the

clock-up mode.

If a break occurs immediately after changing the system clock mode by the user

program, no clock up is performed during oscillations stabilization wait state. Clock

up will be performed when oscillations are stabilized.

- 19 -

MCU-AN-395002-E-V10