Fujitsu LQFP-100P Operation Manual - Page 7

Browse online or download pdf Operation Manual for Motherboard Fujitsu LQFP-100P. Fujitsu LQFP-100P 14 pages. Dsu-fr emulator
Also for Fujitsu LQFP-100P: Operation Manual (16 pages)

Print Page

4. Procedure for Connecting the User System

Before using the LQFP-100P header type5, mount the supplied NQPACK on the user system.

The header board is used combining the emulator. Moreover, connection of a header board and

an adapter board is two flat cables (a standard or Long)appended to the emulator main part. Please

use it.

Refer to the hardware manuals of the emulator or the adapter board about the way to connect.

Connecting

1. To connect the header board to the user system, match the index mark ( ) on the NQPACK-

2. Insert each screw for securing header board in each of the four drilled holes on the header

mounted on the user system with the index mark ( ) on the header board and then insert it (See

Figure 3) . The pin of YQPACK is thin and easy to bent. Insert NQPACK after confirm that the

pin of YQPACK is not bent.

board(See Figure 4).

To tighten the screws, use the special screwdriver supplied with the NQPACK to finally tighten

the four screws in sequence. Please tighten a screw to a diagonal by equal power using a special

screwdriver. Tightening the screws too tight might result in a defective contact.

NQPACK Index ( )

Flat cable connector A

Flat cable connector B

YQPACK

(It mounts in the back)

Header board Index ( )

Figure 3 Index Position