Fujitsu SK-96380-120PMT User Manual - Page 24

Browse online or download pdf User Manual for Motherboard Fujitsu SK-96380-120PMT. Fujitsu SK-96380-120PMT 42 pages. Mb96300 series

Print Page

4.4 CAN Connector (X6, X8)

Two 9-pin D-Sub male connectors are used for the CAN interfaces CAN0 and CAN1. Both
CAN interfaces can be used simultaneously.
Pin Number
Pin Signal
1
2
CANL
3
4
5
6
7
CANH
8
9
Shield
4.5 USER-LEDs & optional LC-Display
Eight LEDs are supplied for user applications. In order to disconnect the LEDs from the
related microcontroller port (Port 09), the resistor network RN1 can be removed.
Instead of the user-LEDs, an alphanumeric LC-Display (optional) can be connected.
The potentiometer RP1 can be used to adjust the contrast of the LC-Display. Pin 15 and 16
of J1 are normally not mounted. If the used LC-Display has pins for LED backlight at this
position, they can be connected here (Pin15: Vcc via 39U/0.5W, Pin16: GND).
The following control signals are provided:
FMEMCU-UG-960001-15
SK-96380-120PMT User Guide
Chapter 4 Connectors
Figure 4-3: CAN Connector
Description
NC
Not used
LOW-level CAN voltage input/output
GND
Ground
NC
Not used
NC
Not used
NC
Not used
HIGH-level CAN voltage input/output
NC
Not used
NC
Not used
GND
Ground
Table 4-2: CAN Connector Signals
- 24 -
© Fujitsu Microelectronics Europe GmbH