Fujitsu SK-96390-100PMC User Manual - Page 21
Browse online or download pdf User Manual for Motherboard Fujitsu SK-96390-100PMC. Fujitsu SK-96390-100PMC 32 pages. Mb96300 series
Print Page
3 Connectors
3.1 Power connector (X12)
The following figure shows the power connection jack X12. This connector is used to
connect an external unregulated DC power supply voltage (9V-15V DC) to the evaluation
board.
Connector X12:
3.2 MCU pin header connectors (X4A/B/C, J1 and J2)
All pins (except oscillator and supply pins) of the microcontroller are directly connected to pin
headers. Pin 1 of the MCU corresponds to Pin 1 of the connector. Pin 2 of the MCU
corresponds to Pin 2 of the connector, and so on.
3.3 CAN Connector (X10)
One 9-pin D-Sub male connector is used for the CAN interface CAN A.
Pin Number
Pin Signal
1
2
CANL
3
4
5
6
7
CANH
8
9
Shield
© Fujitsu Microelectronics Europe GmbH
SK-96390-100PMC User Guide
Chapter 3 Connectors
Shield is connected to GND (-)
+
Center is connected to positive voltage supply (+)
Figure 3-1: Power Connector
Figure 3-2: CAN Connector
Description
NC
Not used
LOW-level CAN voltage input/output
GND
Ground
NC
Not used
NC
Not used
NC
Not used
HIGH-level CAN voltage input/output
NC
Not used
NC
Not used
GND
Ground
Table 3-1: CAN Connector Signals
- 21 -
UG-960017-11