Fujitsu SK-96620_350-64PMC(1) User Manual - Page 35
Browse online or download pdf User Manual for Motherboard Fujitsu SK-96620_350-64PMC(1). Fujitsu SK-96620_350-64PMC(1) 47 pages. F²mc-16lx/fx family, mb96620/350 series, mb90350 series
Print Page
6 Programming the internal Flash Memory
How to load program code into MCU
6.1 Introduction
All Flash devices have an internal boot loader for asynchronous- as well as for synchronous-
Flash-programming:
Asynchronous serial Flash programming via X3 or X5 (UART "A" or UART "B")
Synchronous serial Flash programming via X17 (UART2)
6.2 Asynchronous Mode
This chapter describes the serial asynchronous programming of the internal Flash memory
using „Flash Memory Programmer 16FX‟ in automatic mode.
For serial asynchronous programming SUB-D9 connectors X3 or X5 can be used on the
starter kit. Depending on the applied MCU the UART connection can be selected (see Table
6-1). After selection of on permitted UART connection the jumper settings of the
corresponding UART must be executed (see Table 6-2 and Table 6-3)
MCU Series
MB96620
MB96350
MB90350
6.2.1 UART "A"
Jumper
JP2
(SIN2)
JP1
(SOT2)
Table 6-2: Jumper Settings for Programming via UART "A" (X3)
© Fujitsu Semiconductor Europe GmbH
SK-96620_350-64PMC(1) User Guide
Chapter 6 Programming the internal Flash Memory
Programming
Setting
UART
UART "A"
UART2
UART "B"
UART7
UART "A"
UART2
UART "B"
UART3
UART "A"
UART2
UART "B"
NC
Table 6-1: UART Selection for PC connection
Programming
Setting
UART
UART2
1-2
UART2
1-2
Description
UART2 is connected to X3
UART7 is connected to X5
UART2 is connected to X3
UART3 is connected to X5
UART2 is connected to X3
Not connected
Description
SIN2 is connected to RxD of X3
SOT2 is connected to TxD of X3
- 35 -
UG-960028-12